Connectivity
|
Cannot route this pipeline due to bad
connectivity.
|
Connectivity
|
Inline component <tag> is attached to
Pipeline <tag>, but is not part of the recorded sequence input.
|
Connectivity
|
Item <tag> is listed as part of
sequence input for Pipeline <tag>, but it is not connected to
<pipeline tag>.
|
Connectivity
|
No diameter input or inferable for Pipeline
<tag>
|
Connectivity
|
Pipeline <tag> (diameter <size>):
Has an inconsistency in diameters along its length. Sequence is: <pipeline
sequence>
|
Connectivity
|
Pipeline <tag> (diameter <size>):
Has no segment that matches its nominal diameter. Sequence is: <pipeline
sequence>
|
Connectivity
|
Pipeline <tag> (diameter <size>):
Has a diameter <size> at control valve <tag>, which has size
<size>. Sequence is: <pipeline sequence>
|
Connectivity
|
Pipeline <tag> tees into Pipeline
<tag>, but is not part of the recorded sequence input.
|
Connectivity
|
The nozzle is connected to multiple
Pipelines: <pipeline list>
|
Connectivity
|
The pipeline is directly or indirectly
connected to <tag>, which is not fully connected.)
|
Connectivity
|
The pipeline is missing a terminus.
|
Connectivity
|
The pipeline is missing an origin.
|
Connectivity
|
The pipeline is not connected to anything.
|
Connectivity
|
The pipeline is part of a cycle including
these pipelines <pipeline list>.
|
Connectivity
|
The sequence on Pipeline <tag> has been
set to unordered due to missing tee and/or inline references. Please confirm
the inline sequence in the Connectivity Editor.
|
Connectivity
|
Unable to place pressure safety valve due to
missing inlet connectivity
|