OpenUtilities Substation Help

Multi-line Partial Delete

Used to partially delete a multi-line without losing any previously created breaks.

You can access this tool from the following:
  • Ribbon: Drawing > Home > Multi-lines
  • Toolbox: Multi-lines

Cap Mode Determines whether end caps are created and how they are defined:
  • None — No caps are created. The end cap angle will be 90°. Effect is same as Cut All Component Lines tool.
  • Current — Uses the start cap and end cap definitions of the selected multi-line.
  • Active — Uses the active multi-line definition.
  • Joint — Uses the selected multi-line's joint definition instead of end cap definition. Ensures end cap will always be 90°.