To Place a Multiple Referencelines
To place a
referenceline centered on the active alignment, use the following procedure.
You must have an active tunnel unit and alignment to place a referenceline.
The length, location (station), and orientation (skew) of the referenceline must be specified.
-
Either:
On the
Home ribbon tab, select the
Place>Multi tool in the Reference Line
group.
Or
Key in TDGEOMETRY REFERENCE MULTI
- In the Place Multi ReferenceLines tool settings dialog, specify any fixed settings. These values will be the default for each referenceline placed, but they may be changed for individual referencelines later.
- Type the Number of ReferenceLines to place using the tool.
- Select the Direction Mode to use.
- (Optional) Set the Feature options if needed
-
In the view window, provide the following data points:
- Data point to specify the Start Location.
- Data point to specify the Direction Mode.
- Data point to specify the End Location.
The Place Multi ReferenceLines dialog opens.
- Specify different (skew) angle, station, or lengths for individual referencelines as needed. The station or length is calculated when the other value is entered.
- Click OK. The referencelines are added to the tunnel model on the active alignment.