To Dimension an Angle(s) from an Origin

  1. Select the Angular Dimensioning tool.
  2. Set the mode to Angle Location.


  3. Enter a data point to define the dimension start point. The dimension is measured in a counterclockwise direction from this point.
  4. Enter a data point to define a point on the axis.
  5. Enter a data point to define the endpoint of the dimension.
  6. Enter a data point to define the direction and length of the extension line.
    1. Do one of the following:
      • Go back to step 5 to place another dimension using the same start point.
      • Reset to complete the dimension.
      Figure 1. Dimensioning an Angle from an Origin