OpenRoads Designer CONNECT Edition

Manipulator Settings

Option

Description

Corridor - Element Template

Element template utilizes to draw the corridor boundary in the Create Corridor tool. As a best practice, place the graphics for the boundaries in a construction class to allow for easily turning them off / on as needed.

Corridor Handle Length Factor

The Length Factors are a ratio of the handle length to the width of the corridor. So 1.0 would make the handle as long as the width of the corridor at that point.

Corridor Handle Spacing

The handle spacing either is set to a physical distance as shown or set to zero. If you set to zero you will get 11 handles per corridor regardless of its length. Any non-zero value is used as a distance between handles measured in master units along the horizontal alignment.

Template Drop Element Template

Element template utilized to draw the template drop boundary in the Create Template Drop tool.

As a best practice, place the graphics for the boundaries in a construction class to allow for easily turning them off / on as needed.

Template Drop Handle Length Factor

Single Station Drop Element Template

Single Station Drop Handle Length Factor

Transition Element Template

Element template utilized to draw the transition boundary in the Create Transition tool.

As a best practice, place the graphics for the boundaries in a construction class to allow for easily turning them off / on as needed.

Transition Handle Length Factor