Automatic:
Creates a linear or circular element based on the curvature
Linear: Creates
a linear element based on the regression data.
Circle: Creates
a circular element based on the regression data.
Desired Slew
Left/Right: Desired slew values to the left/right of the geometry.
Unacceptable Slew
Left/Right: Unacceptable slew values to the left/right of the
geometry. These values are also written to the regression points used in the
calculation.
Start
Point: Start point of the regression analysis.
Start
Distance: Distance to the start of the first element in the
complex, excluding gaps.
Start
Point: First point to be used in the analysis.
Nudge
Point: Changes the start point by adding (+) or removing (-) one
point to the current regression analysis.
End
Point: End point of the regression analysis.
End
Distance: Distance to the start of the first element in the
complex, excluding gaps.
End
Point: Last point to be used in the analysis.
Nudge
Point: Changes the end point by adding (+) or removing (-) one
point to the current regression analysis.
Results:
Results for the current state of the regression analysis.
Maximum
Slew: Displays the offset of the point that is farthest away from
the created element. Values close to zero indicate a tight fit.
Standard
Error: Displays the Standard Error (SE) of the regression analysis.
The standard error of the regression provides the measure of the typical
distance that the data points fall from the regression line representing how
tightly the element fits the regression data. Values close to zero indicate a
tight fit.