Manipulator Settings
Settings |
Description |
Corridor - Element Template |
Element template utilizes to draw the corridor boundary in the Create Corridor tool. As a best practice, place the graphics for the boundaries in a construction class to allow for easily turning them off / on as needed. |
Corridor Handle Length Factor |
The Length Factors are a ratio of the handle length to the width of the corridor. So 1.0 would make the handle as long as the width of the corridor at that point. |
Corridor Handle Spacing |
The handle spacing either is set to a physical distance as shown or set to zero. If you set to zero you will get 11 handles per corridor regardless of its length. Any non-zero value is used as a distance between handles measured in master units along the horizontal alignment. |
Template Drop Element Template |
Element template utilized to draw the template drop boundary in the Create Template Drop tool. As a best practice, place the graphics for the boundaries in a construction class to allow for easily turning them off / on as needed. |
Template Drop Handle Length Factor |
The Length Factors are a ratio of the handle length to the width of the corridor. So, 1.0 would make the handle as long as the width of the corridor at that point. |
Single Station Drop Element Template |
|
Single Station Drop Handle Length Factor |
|
Transition Handle Length Factor |
|
Transition Element Template |
The Length Factors are a ratio of the handle length to the width of the corridor. So, 1.0 would make the handle as long as the width of the corridor at that point. |