Define the parameters from the
Design Properties and press enter.
The Apply Changes buttons gets enabled.
Note: If Saddle
Offset is defined, Width Angle is by default set to
180°. Set the Saddle Offset value
to 0, to use the Width Angle property. The Width Angle
value ranges from
5° to
355°. If the Saddle Offset value is
greater than
0, the Width Angle automatically changes
to
180°.
Click Apply Changes and close the dialog.
The changes are shown on the component.
To change the plate location and position of olet:
Select the component.
The Drag to Slide and Drag to Rotate arrows
appears.
Select one of the following handlers,
Click
Drag to Slide handler to move the plate.
You can move the plate forward and backward as desired.
Click
Drag to Revolve handler to change the
position of olet. You can revolve the olet to any degree.