Support Dimensioning
|
Support level dimensioning is used for both supports
and dimensioned annotations.
- Hide
Support Dimensions — Do not show support level dimensions.
- Skip Shop
Support Dimensions — Do not break support dimensioning at supports
marked as shop.
- Skip
Field Support Dimensions — Do not break support dimensioning at
supports marked as field.
- Place
Support Dimensions Inverted — Place the support dimension opposite
to component/overall dimensioning.
|
Reference Dimensions
|
Reference dimensions reference to an existing column
intersection. The column intersection may be specified in the modeling system
or can be determined from the external grid definition.
- Show
Reference Dimensions — Show reference dimensions in the isometric.
If not show there still will be an annotation element holding the data.
- Automatic —
When the modeling system does not provide a reference dimension and this option
is checked, a reference dimension will be added automatically. An intersection
point will be determined (elbow, tee) and the nearest column intersection will
be determined from the external grid definition.
- Display
As Label — Normally reference dimension is shown graphically. Check
this option to display it as a label.
- Level
Name for Reference Dimensions — Determines the level used for
reference dimensions. A Reference Dimensions level is defined by default, but
this can be modified.
|
Suppress Dimensions
|
The options here are conditions which determine
whether or not to suppress branch dimensions.
- Hide
Branch Dimensions — Suppress dimensions on branches insofar certain
conditions are met wrt to diameter and number of components.
- Use
Diameter Threshold — Do not suppress branch dimensions when the
nominal diameter of the branch is above the specified value. The value can be
specified in decimal inches or millimeters. The conversion factor used is 25.
- Use
Component Count Threshold — Do not suppress branch dimensions when
the amount of components in the branch is above the specified value.
|
Dimension Existing Pipework
|
- Dimension
Existing Pipework — Check this to dimension pipe work marked as
existing .
|
Use Dual Dimensions
|
Will display the dimension in both MM and Inch value.
|
Show Allowance
|
Will include the weld allowance on the dimension.
|
Format
|
Defines the format which the weld allowance will be displayed.
|