Copper Settings

From the Modify/Delete section of the Copper Tab select the Copper Settings command:
The Settings dialog will display:

Note: One of two methods must be used to route copper:

Calculate Distance - Uses the spatially accurate DGN seed file with the correct projection and working units in order to route and calculate sheath lengths and place device model features in the correct location as they are drafted.
Link to Strand - Uses the drafted OpenComms aerial, underground and duct facilities to define the sheath lengths and device locations as they are linked.

Use the check boxes under the Routing section of the Settings Dialog (above) to set these.

Link To Strand: Link copper devices to the OpenComms Strand or Duct features while routing the network.
Auto Route: Route copper by selecting a start and ending location.
Calculate Distances: Calculate sheath lengths and device locations by distance and coordinates in the DGN.
Conn Same Sheath: Allows copper connection within the same sheath.
Default Fiber Status: Set the default status for fibers. FIBER ONLY
Logical Fiber Numbers: Use logical numbers for fibers in X-Section Review, Manual Connections, Retain Order Splice Reports, etc. FIBER ONLY
Allow Edit of Customer Record: Allows customer records to be edited.
Write Traces To File: Allows trace to remain displayed on the map. If activated, the trace is written to the file and remains on Level 42 until it is deleted. The trace remains displayed on the map.
Fiber View Mode: View modes for XSection review dialog for fiber. FIBER ONLY
OS mode: Detail Mode on same XSec review: FIBER ONLY
Copper View Mode: View modes for copper. (Not used currently.)
Port Name View Mode: View modes for port names FIBER ONLY.