Populate Sheath Information

The Populate Sheath Info command places or updates fiber sheath information stamps on the drawing.

Post Sheath Information

From the Modify/Delete section of the Fiber Tab click on the Populate Sheath Info command icon:
The Select Info Block Cell dialog box opens (if more than 1 sheath info is defined in the Fiber/Copper/ISP setup).
Select a cell type and click OK.
Select a span on the map.
Place the Sheath Information Cell on the map. Information of the selected sheath displays in a cell as defined in the Sheath Information Setup dialog box.

Update a Single Sheath Information Stamp

From the Populate drop-down select Update Single under the Populate SheathInfo command.
Select a span or the Sheath Information Cell. The information contained in the cell reflects the updated sheath information.

Update All Sheath Information Stamps

From the Populate drop-down select Update All under the Populate SheathInfo command.

Note: This command will update information represented in ALL fiber sheath information stamps in the OpenComms project. The time to run this command depends entirely upon the amount of data in the database.