Insert to Existing
The Insert to Existing command is used to insert a fiber device in an existing span break point. When in link to strand routing mode, a natural fiber span break point is created at each pole, duct enclosure or pedestal location as a sheath is made up of many linear segments. If using Link to Strand mode, there is no need to use the Break command to define a sheath break point if inserting at an existing facility location. The Break command would only be used in Link to Strand mode if inserting a splice enclosure or other device at a mid-span location.
Start the Insert to Existing Command
- Select the Insert to Esisting drop-down from the Placement section of the Fiber Tab.
- Select the first span of sheath to insert into the splice enclosure.
- Select the second span of sheath to insert into the same splice enclosure.
- Select the splice enclosure.
- The fiber sheath is connected to the existing splice enclosure.