Used to change the end cap of a multi-line.
You can access this tool from the following:
- Ribbon:
- Toolbox:
Multi-lines
Setting | Description |
---|
Cap Mode |
Sets type of end cap:
- None — Removes any end caps. The end cap angle will be 90°. Effect is same as Cut All Component Lines tool.
- Current — Does not change the end cap. Enabled only when Adjust Angle is turned on.
- Active — Uses the active multi-line definition for the end cap.
- Joint — Uses the multi-line's joint definition instead of its cap definitions. Ensures end cap will always be 90°.
|
Adjust Angle |
If on, lets you adjust the angle of the end cap. |
Tip: Using AccuDraw with the Adjust Angle option makes it easier to make the end cap perpendicular to the rest of the multi-line.