Box | Depth Box | Length
Box | Width |
Positive <numeric value>
- Sets dimension of sides of tee box at the juncture where three branches meet.
|
Branch Horizontal Offset |
Positive <numeric value>
- Sets offset to connection at End2 farther from the center on the box side along the depth. Higher values extend the box depth to accommodate the offset.
|
Branch | Length |
Positive <numeric value>
- Sets branch length of tee. Center line distance between side branch divergence point to End3 connect point.
|
Branch | Outer Diameter |
Positive <numeric value>
- Sets outside diameter of Side branch (End3).
|
Branch Vertical Offset |
Positive <numeric value>
- Sets offset to connections at End1 and End3 farther from the center on the box side along the length. Higher values extend the box length to accommodate the offset.
|
Connection 1 | Length (L1) |
Positive <numeric value>
- Sets the straight length of connection at End1.
|
Connection 2 | Length (L2) |
Positive <numeric value>
- Sets the straight length of connection at End2.
|
Connection 3 | Length (L3) |
Positive <numeric value>
- Sets the straight length of connection at End2.
|
Connection | End Type |
fl -<numeric value>
- Sets and sizes end with a flange connection.
m -<numeric value>
- Sets and sizes end with a male connection.
fe -<numeric value>
- Sets and sizes end with a female connection.
Separate End Type entries for each End Spec with a semi colon. Example: ce-0.2;fe-.03 creates a compression at End1 with size 0.2, and a female connection at End2 with a clearance of 0.3.
|
Plumbing Connection | Outer Diameter |
Positive <numeric value>
- Sets pipe outside diameter for End1 and End2.
|
Tag |
<alpha-numeric characters>
- Sets tag value visible in output of drawing composition in dynamic view. Separate tag strings with a semi colon.
|
Tee Length |
Positive <numeric value>
- Sets distance between End1 and End2 of main pipe of tee.
|
Total Length |
Positive <numeric value>
- Sets distance between End1 and End2 of fitting.
|