BMP_VibrationPad "default"
|
Vibration Pad — Anti-vibration
pads resolve problems with vibrations and machine installation. Vibration pads
are used in many applications for isolating noise, prolonging machine life,
reducing maintenance costs and reducing excessive wear and tear.
|
BMP_PumpBaseMounted "Base Mounted"
|
Base Mounted Pump — The
horizontal base mounted pumps are centrifugal pumps that are single, end
suction type with radially split, top center-line discharge, self-venting
casing. Motor rotation can be set to Left or Right handed.
|
BMP_PumpDiaphragm "PumpDiaphragm"
|
Diaphragm Pump — A diaphragm
pump (Membrane pump, Air Operated Double Diaphragm Pump (AODD) or Pneumatic
Diaphragm Pump) is a positive displacement pump that uses a combination of the
reciprocating action of a rubber, thermoplastic or teflon diaphragm and
suitable valves either side of the diaphragm to pump a fluid. The discharge
type can be set to horizontal vertical or at side.
|
BMP_PumpDiesel "Diesel"
|
Diesel Pump — Diesel pumps
that run on internal combustion using diesel engine as a prime mover powers the
main pump via mechanical energy with vertical turbine.
|
BMP_PumpDieselHorizontal "Horizontal Diesel"
|
Diesel Pump Horizontal —
Houses hydraulic motors in horizontal configuration and diesel engine, rated by
their ability to pump a specific volume of water, usually measured in gallons
per minute (gpm) at a rated pump pressure and pump speed.
|
BMP_PumpHorizontalSplitCase "Horizontal Split"
|
Horizontal Split Pump — The
double suction impeller design help reduce the axial thrust on its rotating
element helps pump to balance the forces on impeller and split case design
offer fast maintenance and lower down time.
|
BMP_PumpJockey "Jockey"
|
Jokey Pump — Jockey Pump is a
pressure-maintenance pump applicable to conveying non-corrosive liquid at
different temperature and with different flow rate and pressure. These devices
consist of a three-part assembly.
|
BMP_PumpMotorMounted "Motor Mounted"
|
Motor Mounted Pump — Motor
mounted version of the horizontal end suction pump, with flanged connections.
Radially-split volute with center-line discharge. The motor is adequately rated
to accommodate impeller radial loads and residual hydraulic thrusts. The
impeller is mounted on an extension of the motor shaft with minimum overhang.
Motor rotation can be set to Left or Right handed.
|
BMP_PumpSump "PumpSump"
|
Sump Pump — Sump pumps are
used to remove water accumulated in a sump pits, in the low level ground basin
and keeps basement or crawl space dry. Sump pumps send water away from a house
to any place where it is no longer problematic, such as a municipal storm drain
or a dry well.
|
BMP_PumpVerticalDualArm "Dual Arm"
|
Dual Arm Pump — A Dual Arm
pump is a two pump assembly with one volute. They can run main and standby or
in parallel. The volute has a swing discharge port to hydraulically separate
the casings to prevent re-circulation when only one pump operates. One pump can
also be fully isolated for maintenance while the other is still fully
operational.
|
BMP_PumpVerticalSplitCoupled "Split Coupled"
|
Split Coupled Pump — Split
coupled inline pump design enables you to change the seal without disturbing
the motor or piping. The axial load is hydraulically balanced to increase
bearing life, deliver better pump efficiencies. The axially split, spacer type
rigid coupling permits seal maintenance without disturbing the pump or motor
connections. Motor rotation can be set to Left or Right handed.
|