Known Issues
Known Issues of OpenBuildings Designer CONNECT Edition.
- It is recommended not to share datasets with both Legacy and ProStructures mode. Datasets function works best when the projects using them use the same structural elements.
- Assembly Builder
- Before using Update 10, DataGroup Upgrade Utility must be run to make sure all new properties are used on elements.
- Undo/Redo functionality is not supported in Energy Simulator and Program Manager.
- OpenBuildings ™ Station Designer companion product is based on Neutral Metric Dataset.
- Content
Creator
- In specific instances, when using the placement method By Face to create a connection point the tool will fail to create this point and a message of Invalid Element is listed on the tooltip. This is due to the cell being created with surface modeling rather than using MicroStation solids. In this case the connections can be created using the placement method By Point.
- During the component
creation process, you may encounter a pop-up message as
"Add at least one HVAC/Plumbing connector to
create the Content," and an error message in the
Message Center as
"Connection combination do not exist". This is
because you are trying to create a connection combination of EndSpec, which is
not delivered.
Resolution: Close OpenBuildings Designer and launch with Admin rights i.e. Run as administrator and execute the create component workflow again.