Pick Data Points:
|
Used to setting up new segment by supplying the
data points either in 3D or 2D.
|
3D points in active coordinate system
|
When on, floor segment being traced uses active
coordinate system. The data points supplied follow desired orientation and
inclination. Using AccuDraw ensures accurate result.
|
2D points on plan view
|
When on, allows setting required Elevation, Pitch
angle and Orientation in plan view.
-
Elevation from roof datum – Used to
elevate the floor segment above the plane it’s being traced in the active
floor. The elevation value is supplied in default unit.
- Pitch
angle – Used to tilt the floor segment in a desired angle. The
pitch angle supplied in default unit determines the tilt of the floor segment.
-
Orientation – Used to set the
orientation of the floor segment. The orientation angle determines the
alignment of the edge of the floor segment.
- First
edge is horizontal and bottom – when on, disables orientation and
aligns the floor segment edge in horizontal at bottom.
|