Auto Size |
Radius
- Radius to Diameter Ratio follows changes of Radius.
RadToDia
- Radius follows changes of Radius to Diameter Ratio.
|
Bend Angle |
Positive <angle value>
- Sets angle between outlets.
|
Bending Radius |
Positive <numeric value>
- Sets center line radius/radii for wye side branches.
|
Branch | Connection Length |
Positive <numeric value>
- Sets the straight length at End3.
|
Center to Inlet/Outlet Height |
Positive <numeric value>
- Sets the distance between the main branch (End1/End2) and the heel (End3) center lines.
- Sets the distance between the End1 center line and the trap center line.
|
Center to Inlet Length |
Positive <numeric value>
- Sets distance between the End1 connect point and End2 center line.
|
Center to Outlet Height |
Positive <numeric value>
- Sets distance between the End2 connect point and End3 center line.
|
Connection | End Type |
fl -<numeric value>
- Sets and sizes end with a flange connection.
m -<numeric value>
- Sets and sizes end with a male connection.
fe -<numeric value>
- Sets and sizes end with a female connection.
Separate End Type entries for each End Spec with a semi colon. Example: fl-2;fe-.13 creates a flange at End1 with size 2, and a female connection at End2 with an overall reduction of component's dimensions of .13
|
Group Type |
<Gtype>
- Set by Manufacturer Catalog dialog when available. Data property representing fitting angle type.
Example: 90L, 90U etc. |
Inlet | Connection Length |
Positive <numeric value>
- Sets the straight length at End1.
- At End2, in case of Twin Elbow.
|
Inlet | Outer Diameter |
Positive <numeric value>
- Reduced branch outside diameter.
|
Inlet to Outlet Horizontal Distance |
Positive <numeric value>
- Sets distance between End1 and End2 center lines.
|
Length (L) |
Positive <numeric value>
- Sets distance between End1 and End3 (heel) connect points.
|
Outlet 1 | Length Outlet 2 | Length
|
Positive <numeric value>
- Sets the straight length at End2.
- in case of Twin Elbow, Outlet 1 and Outlet 2 at End1 and End3 respectively.
|
Inlet | Outer Diameter |
Positive <numeric value>
|
Outlet 2 | Outer Diameter |
Positive <numeric value>
- Side branch (End3) outside diameter.
|
Radius to Diameter Ratio |
<numeric value> greater than or equal to 1
- Sets center radius by solving equation: centerline radius = depth1 (D1) x <value>
|
Standard Angle |
<angle value> between 5° and 90°
- Closest catalog match for angle property. Set by Manufacturer Catalogs.
|
Union Diameter |
Positive <numeric value>
- Sets diameter of Union bolt at End1.
|
Union Length |
Positive <numeric value>
- Sets straight length of Union bolt at End1.
|