Assign & Analyze Connection dialog
Used to map flow
types with available end connections in the route being selected for sizing
utility for both Duct System and Pipe System sizing. The number of connections
available is based on the number of ends the source —the air handling unit and
in case of HVAC, and the supply unit in case of plumbing is configured with.
The mapped preferences are retained when a system is loaded for analysis.
Opens when the
Load System button in the Sizing System Summary
dialog is pressed and the first component, usually the source of the system in
the route is selected in the view. The upper part of dialog settings deals with
assigning flow types to the connection ends
available in the selected source, whereas the lower interface is used to pick
an end connection to load the system for
analysing system sizing.
Setting | Description |
---|---|
Assign Connection Types | Used to map one or more connections to a flow type
each.
|
Connection to Analyze | The end connections that are mapped for respective
flow types are listed here. The mapped ends display the flow they are mapped
with in the parenthesis.
Note: An
abbreviated letter corresponding to the flow types (s, e, r or f) being mapped
during the load, is suffixed with the Duct Section numbers listed in
Duct Sizing Section Summary table and in
Fitting Loss Coefficient Summary table.
Cancel escapes the dialog. |