Height
|
Specifies the height of the form, unless a shape or
form above prohibits extrusion. If a shape above only partially blocks
extrusion, Height controls the portion of the form that can be extruded past
the overlying shape or form. Enabled when the
option is selected.
Note: Height
extrusion direction is defined by either the Z-axis, perpendicular to the view;
or, if AccuDraw is on, by the AccuDraw Z-axis.
|
Width
|
Specifies the width of the form.
|
Placement icon
|
Controls the position of the form relative to the
placement points which define the start and end points of the form:
- Places
the form to the left of the creation line (baseline).
- Places
the form centered on the creation line.
- Places
the form to the right of the creation line.
|
Method
|
Controls what the new placed form is parallel to:
-
Forms — The new linear form is placed
between Building forms.
-
2 Imaginary Lines — The new linear form
is placed between imaginary lines.
|
Top
|
Controls the geometry and location of the top of a
form:
- Fixed
Height — The form has a uniform height as specified in the
Height field. The top face of the form
is parallel to the bottom face.
-
Connect Shapes — The form is extruded so
that it connects to one or more shapes and/or forms. Selecting
Connect Shapes displays the
Delete Construction check box, which
enables or disables the deletion of the limiting shapes and/or forms.
-
Connect 3 pts — The top of the form is
located in an imaginary plane defined by three data points.
-
Connect 2 pts/View — The top of the form
is located in an imaginary plane constructed through two data points and
perpendicular to the view where the last data point is entered.
|
Delete Constructions
|
Enabled when the
option is selected, limiting shapes and forms are
deleted when on.
|
3D Dynamics
|
During placement, controls whether the display of
the form being placed dynamically displays in 3D or in 2D:
If on, forms being placed dynamically display in
3D.
If off, forms being placed display in 2D.
|
Roof Tolerance
|
Enabled when the
option is selected, a curved connecting shape is
stroked using the specified tolerance before it is used to create a roof on the
form when on. The curved shape is used to create a feature on the form that is
the exact shape of the curve when off.
|