| Pick Data Points:
|
Used to define new segment by supplying the data
points either in 3D or 2D.
|
| 3D points in active coordinate system
|
When on, floor segment being traced uses active
coordinate system. The data points supplied follow desired orientation and
inclination. Using AccuDraw ensures accurate result.
|
| 2D points on plan view
|
When on, allows setting required Elevation, Pitch
angle and Orientation in plan view.
-
Elevation – Used to elevate the floor
segment above the plane it’s being traced in the active floor. The elevation
value is supplied in default unit.
-
Pitch angle – Used to tilt the floor
segment in a desired angle. The pitch angle supplied in default unit determines
the tilt of the floor segment.
-
Orientation – Used to set the
orientation of the floor segment. The orientation angle determines the
alignment of the edge of the floor segment.
|
Used to create the roof sections
that make up a roof model by selecting surface elements. You can display the
project building as a reference.
