Thickness
|
Specifies the thickness (or height) of the slab.
|
Top of Slab
|
Sets the Z axis distance from the active ACS to the
top of the slab.
Top of slab can be a negative value.
Top of Slab works relative to
the active floor elevation at time of placement. When the ACS Plane and ACS
Plane Snap locks are turned off,
Top of Slab is relative to the Active
Depth.
|
Side Angle
|
Controls the angular position of the slab’s edge
faces.
-
Angle — Sets the angle of the edge faces
between the base shape and the top shape of the form.
- When the angle is 0 (zero), the edge faces
are perpendicular to the base shape.
- When the angle is positive, the edge face
angle starts from the top edge of the slab and indents inward toward the bottom
edge.
- When the angle is negative, the edge face
angle starts from the bottom edge of the slab and indents inward toward the top
edge.
-
Horizontal — When viewing the slab form
with the Base ACS active, the sides of the slab form display parallel to the
global X-Y plane. In other words, the sides should appear as single line edges
in an elevation view.
-
Vertical — When viewing the slab form
with the Base ACS active, the sides of the slab form display perpendicular to
the global X-Y plane. In other words, the sides should appear as single line
edges in a plan view.
|
Side Angle text field
|
Is available when
Side Angle is set to
Angle (see above).
|
Auto Connect
|
Trims form intersections and form ends during
placement, when on. Also recognizes conditions when forms intersect with other
elements, such as grid lines and square columns. Under these conditions, forms
are trimmed during placement as well.
|