Placement Icon
|
- Sets the position of the linear form relative to the
selected shape:
- The form is constructed above (in the positive Y axis of)
the selected shape.
- The linear form is constructed centered on the selected
shape.
The linear form is constructed below (in the negative Y axis
of) the selected shape.
|
Height
|
Specifies the height of the form, unless a shape or
form above prohibits extrusion. If a shape above only partially blocks
extrusion, Height controls the portion of the form that can be extruded past
the overlying shape or form. Enabled when the
option is selected.
Note: Height
extrusion direction is defined by either the Z-axis, perpendicular to the view;
or, if AccuDraw is on, by the AccuDraw Z-axis.
|
Angle
|
Specifies the angle between the form face and base
for each side. Select one angle option for each side face, in order, as
identified in the tool settings window:
-
Horizontal — The face is parallel to the
global XY plane.
-
Vertical — The face of the form is
perpendicular to the global XY plane.
-
Angle — Specifies the number in degrees
of the angle between the base shape and the face of the form. Entering
0.00 results in a face perpendicular to
the shape’s base; a negative value produces an angle greater than 90 degrees; a
positive value produces an angle less than 90 degrees.
|
Delete Constructions
|
When on, the element from which the linear form was
extruded is deleted.
|