Height
|
Specifies the height of the form, unless a shape or
form above prohibits extrusion. If a shape above only partially blocks
extrusion, Height controls the portion of the form that can be extruded past
the overlying shape or form. Enabled when the
option is selected.
Note: Height
extrusion direction is defined by either the Z-axis, perpendicular to the view;
or, if AccuDraw is on, by the AccuDraw Z-axis.
|
Width
|
Specifies the width of the form.
|
BaseOffset
|
Sets the Z axis distance between the elevation of
the active floor and the elevation of the item being placed (usually the bottom
surface). Base Offset can be a negative value.
BaseOffset works relative to
the active floor elevation at time of placement. During instances when the ACS
Plane and ACS Plane Snap locks are turned off,
BaseOffset is relative to the Active
Depth.
|
Placement icon
|
Controls the position of the form relative to the
placement points which define the start and end points of the form:
- Places
the form to the left of the creation line (baseline).
- Places
the form centered on the creation line.
- Places
the form to the right of the creation line.
|
Tolerance
|
Controls the smoothness of the curve form. Larger
tolerances result in a rough curve form and smaller tolerances result in a
smooth curve form.
- Coarse curve shape
– as the tolerance value increases, the number of approximating line segments
composing the curve form is reduced. The result is a more coarse curve shape.
- Smooth curve shape
– as the tolerance value decreases, the number of approximating line segments
composing the curve form increases. The result is a more smooth curve shape.
|
Delete Constructions
|
Enabled when the
option is selected, limiting shapes and forms are
deleted when on.
|
Separate Forms
|
Extrudes individual linear forms from each segment
when on. Extrudes all segments of the linear element into one form when off.
|