Layout
Used to modify the depiction of plates individually. At insertion, the plates obtain the settings that were made and thus can be overwritten individually.
| Setting | Description |
|---|---|
| Layout | Here, you specify how the plate has to be depicted. |
| Holes | Here, you specify the depiction of drill holes. |
| Modeller | The component part is displayed by means of the facet-modeler. Normally, the software independently decides when the modeler has to be used for depiction. However, you can explicitly define it using this option. If the modeler has to be used, you cannot switch it off. |
| Acis | The ACIS-modeler is used for depiction instead of the facet-modeler. ACIS is much slower but exacter than the facet-modeler. Please note that it is not possible to mix ACIS- and facet-modeler volume models. |
| 2D Display | A calculated 2D-depiction depending on the current view direction is displayed instead of standard 3D-depiction. |
| Grid | A plate grid is displayed on the upper side of the plate. This grid represents a gridiron or similar things. |
| Centerline | The centerline of the plate is displayed |
| Part Label | The object name will be displayed dynamic? at the object. |
| Short Name | The name of the component part is displayed dynamically at the part. The position depends on the angle of vision. The settings are made in the global settings. |
| Only view ports |
The element names will be displayed in an activated and prepared view port. Please enter STRUCTURAL_VIEWPORT_DISPLAY at the command prompt. |
| ECS Axes | The Entity Coordinate System is displayed. It mainly serves for verifying purposes. |
| Transparency | The part is displayed transparent at shading. |