Used to set the dimensions of top and bottom holes in
length and width directions of the funnel.
| Setting |
Description |
| Top Holes / Bottom Holes.. in Length Direction
|
-
With
Holes in Length - Enables settings for holes in length direction.
-
Length - No
Holes ? Sets the number of whole on length side of the plate.
-
Diameter ? Sets
the diameter of the hole.
-
End
Edge Distance ? Sets the distance of exterior holes from the end
edge.
-
Gause
Distance ? Sets the position of center of hole from the plate edge.
Preferably set less than radius of the hole.
|
| Top Hole / Bottom Holes.. in Width Direction
|
-
With
Holes in Width - Enables settings for holes in width direction.
-
Width
- No Holes ? Sets the number of whole on width side of the plate.
-
Diameter ? Sets
the diameter of the hole.
-
End
Edge Distance ? Sets the distance of exterior holes from the end
edge.
-
Gause
Distance ? Sets the position of center of hole from the plate edge.
Preferably set less than radius of the hole.
|
