| Width
|
Sets he width of the ladder as clear dimension
between the uprights.
|
| Height
|
Sets he height of the ladder without possible
projection as help for climbing out.
|
| Riser
|
Sets a desired distance between the rungs. Ladder
tool divides the distances between first and last rung regularly according to
this specification and the value is rounded up or down correspondingly.
|
| Calc. step spacing
|
Displays the actual resulting distance between the
rungs.
|
| Distance to floor
|
Sets the distance between the upper edge of the first
rung and the ground area of the ladder.
|
| Top distance
|
Sets the distance between the upper edge of the last
rung and the climbing out surface of the ladder.
|
| Offset
|
Sets the height of the rails above the top of the
ladder, along help for climbing
out surface of the ladder (axis measure).
|
| Stringer
|
Sets the distance of the rails to the backside. This
is the depth of the help for climbing out (axis measure).
|
| Sharp bend
|
Displays the value for the front jump-in of the help
for climbing out (axis measure), when created with a bend.
|
| Angle
|
Sets the angle for the ladder inclination, value
between 70? and 90?.
|
| Dynamic
|
When checked, you can monitor the modification of
settings immediately on screen.
|
| Draw diagonal
|
When checked, a diagonal of the actual structural
element is drawn in the ladder to support an easier selection.
|
| Fit ladder Rung
|
When checked, the rungs are adapted to the uprights.
Round tubes are e.g. cut with each other.
|
