Provides possibility of rounding off the railing head of
the handrail at its corners in different ways or to combine it with the other
component parts.
These default settings can be individually set for the beginning
and the end of the handrail.
Setting
Description
Handrail outer post - junction
Start /
End (Selection list) ? Sets the form of the handrail?s end.
Align
As Is ? Leaves the alignment as is. No detailing takes place.
To
outer edge ? The handrail is extended up to the outer edge of the
post.
Angle
cut ? The handrail and the end post are cut to build a mitre joint.
Insert bend
?The handrail and the end post are combined by means of a bent part. When
selected, activates the
Radius setting.
Radius ? Sets
the arc radius for rounding off. The value is defined either as absolute
numeric or as many times the amount of the handrail diameter. Enter e. g. *2.
Handrail outer oost - Junction with excess length
Start /
End (Selection list) ? Sets the form of the handrail?s end.
Additional shape parts are added in the handrail outside the end post.
Align
As Is ? Leaves the alignment as is. No detailing takes place.
Angle
cut ? The additional shape parts in the handrail are cut to build a
mitre joint.
Insert bend
?The additional shape parts in the handrail are combined by means of a bent
part. When selected, activates the
Radius setting.
Link with
/ Type
? The selected option sets the height the handrail
be extended to the bottom, by inserting a knee-high guardrail above, center or
below (if they exist), with an additional perpendicular part added.
Upper
rail ? Sets the cut / bend at the upper rail of the railing.
Middle rail ?
Sets the cut / bend at the middle rail of the railing.
Insert bend
?Sets the cut / bend at the lower rail of the railing.
?
Radius ? Sets
the arc radius for rounding off. The value is defined either as absolute
numeric or as many times the amount of the handrail diameter. Enter e. g. *2.
Close ? When
checked, the handrail extends up to the end support after detailing.
