Weld Group Settings dialog

Setting	Description
Create Group	When checked, a new group is formed out of the two component parts, unless it already exists.
Treat as one	If this option has been activated in the CAD system the group is set on this selection mode.
With Welds	The weld seams are integrated into the group as well.
Min. Weld Length	A weld seam created using this command may not be shorter than the indicated length.
Gap	The minimum gap between these parts is specified. If the gap is bigger than the specified value, the parts will not be welded. The value should not be equal 0 to avoid problems with tolerances.

Create Group

When checked, a new group is formed out of the two component parts, unless it already exists.

Treat as one

If this option has been activated in the CAD system the group is set on this selection mode.

With Welds

The weld seams are integrated into the group as well.

Min. Weld Length

A weld seam created using this command may not be shorter than the indicated length.

Gap

The minimum gap between these parts is specified. If the gap is bigger than the specified value, the parts will not be welded.

The value should not be equal 0 to avoid problems with tolerances.