Match and Extend Tool
The Match and Extend Tool automates the Single Rebar Distribution placement. The tool is used for placing additional rebars like corner rebar, wall , slab , dowels etc.
Note: Match and Extend
Tool is accessed only through
Keyin.
- By selecting two RebarSet, Single Rebar Distribution rebar is created automatically with guidelines.
- Newly created Single Rebar Distribution takes all bar properties such as Bar size, Bar Grade, Coating, Spacing, Level etc from the first RebarSet which the user selects.
- The Match and Extend tool clears all the previously used End Condition data automatically from Single Rebar Distribution dialog before rebar getting placed and the new data is re-written according to user input.
Wall
Corner Rebars
To stop
Corner bars before Vertical bars
- By selecting vertical RebarSet from the second wall the rebar is placed.
Non
perpendicular Corner Walls with no direct connection
- By selecting the Non perpendicular corner walls with no direct connection the rebar is placed.
T
Connection Wall
- Case 1: By selecting the second RebarSet on the direction the rebar is placed.
- Case 2: By getting rebar leg on other direction the rebar is placed.
Wall
vertical dowels from footing
- Run the Keyin.
- By selecting wall vertical RebarSet, the bar properties are taken and aligned.
- By selecting the second RebarSet from footing the rebar is placed.
Slab to
Slab dowels with single leg
- Run the Keyin.
- By selecting the first slab RebarSet and the second slab RebarSet, the rebar is placed.
Key-in: