To modify all supportlines in the active unit, use the following procedure.
This procedure is used to modify existing supportlines.
Note: You cannot add new supportlines or delete existing supportlines
within this interface.
-
Either:
On the Home ribbon tab, select the Modify tool in the Support Line group.
![](GUID-CDDB9AE4-CFBF-40F1-AE3B-54ADD82EF327-low.png)
or
key in
bmgeom
supportline
modifymulti
The Modify Multi Supportlines dialog opens.
-
Modify the support lines in the table as needed.
-
Click OK.