To place concrete diaphragms
Concrete diaphragms can be placed transversely between beams in a span. To place concrete diaphragms between concrete beams, use the following procedure.
- Either:
- Select the beam group:
- For the selected span from the list of spans, to place diaphragms between beams, select the start and end beam, the thickness of the diaphragm, vertical (top and bottom offsets), horizontal offsets in the default table.
- By default the diaphragms go from center line of beam to center line of beam, but you can input a positive or negative horizontal offset to adjust the transverse location of the diaphragms.
- You can also specify a skew angle and concrete material for the layout
- Next specify the locations along the selected span where you would like to place the diaphragms and input the distances measured from the support line.
-
Click
to add the diaphragms at the desired locations
- To place a diaphragm at the end of a span, make sure the thickness for the diaphragm is large enough to extend to touch the beams at the location.
- You can now click Copy to copy the defined diaphragm layout from the current span to the other spans.