Basic Data
|
- Lap
Method – Sets the method for the lap, selected one from the three
options:
Length,
Bar Diameter, and
Mechanical Device.
- Lap
Length / Multiplier
– When
Length is selected as the Lap Method , this
value set in the adjacent field will be used for bar laps.
When
Bar Diameter is selected as the Lap Method,
then type to use and the calculated lap length is shown in the
Multiplier field.
It is disabled for
Mechanical Device method.
Mechanical Device method enables the Manufacturer
/Device settings:
- Manufacturer –
Sets All or one of the Manufacturers from the drop-down list.
- Type – Displays
the types of laps. You can set All or one of the Types to narrow the devices
list.
- Device – Lists
the devices in a given type for the selected manufacturer. Select required
device from the list to proceed lap settings.
|
Automatic Lap
|
When checked, enables setting automatic lap:
- Maximum
Stock – Sets the percentage to use laps at the maximum bar length.
Type a percentage in the
% Over field to allow this amount over
the maximum length.
- Stagger
Laps – When checked, staggers the bar laps by the indicated
distance set in the next field.
- Stock
Length – Sets the bar stock length for the bar size used (default
is 60'-0").
- Min
Length – Sets the manufactured length for the bar size used
(default is 60'-0").
|
Manual Lap
|
When checked, enables setting manual lap:
- Anti-Seismic –
When checked, restricts seismic detailing. Enables the Clear Height (Hn)
setting.
- Stagger
Laps – When checked, staggers the bar laps by the indicated
distance set in the next field.
- Floor
Index / Label – Lists the laps located in the current floor,
created with the add
tool.
Note: removes the selected lap from the
list.
|
Current Floor Lap Location
|
- Create – When
checked, enables setting dimensions and offsets to the lap being added in
current floor.
- Label – Sets
the label assigned to each lap added in the list.
- From
Bottom / From Top – Sets the lap location offset measured from
either bottom or from top. When
- Build-In
Location – Enabled for
From Bottom. When checked, the
build-in location is taken for floor lap location.
- Larger
Width (Hc) – Displays the larger width value for the lap.
- Non Lap
Zone – Displays the non lap zones.
- Bottom
Embedded Depth – Sets the depth embedded in the bottom.
- Clear
Height (Hn) – Sets the lap height, for Anti-Seismic lap.
- Lap
Location Offset – Sets the offset distance of lap from the
bottom/top.
|