Beam Reinforcing - Longitudinal Reinforcing tab
Used to enter values that define a single reinforcement cage for a concrete beam.
The cross section
displays the main reinforcing bars. Clicking a bar in the section when a rebar
type is selected in the right table will use this bar type for this bar.
Setting | Description |
---|---|
Zone Data |
|
Reinforcing Data |
|
Left / Right Offset | The distance from the left end / right end of the rebar cage to the end of the beam. |
End Conditions | The following descriptions apply to all start and
end options.
Type – Select the type of end condition for each position:
|
Rotation | Type a rotation angle (in degrees). Click to rotate the bar by increments of 90 degrees. |
Edit End Condition Values | When you select an end condition type, the standard values and angle are applied. If necessary, click Edit End Condition Values to enter custom end condition settings. See Rebar End Properties dialog. |
Status | Indicates if you have used standard or user-defined end conditions. |
Adds a new line to the corresponding table and clears the controls in the editing area allowing a new longitudinal reinforcement zone or bar to be entered. | |
Deletes the current line from the corresponding table. |