Rebar Location
|
Top a nd Bottom Locations enable the Rebar level
settings:
- All Rebar
Levels – When checked, allows selecting Rebar Levels.
- Rebar
Levels – Sets the selected rebar level picked from the list all
rebar levels.
Rebar Location can also be set to
Left or to
Right.
|
Basic Data
|
- Lap
Method – Sets the method for the lap, selected one from the three
options:
Length,
Bar Diameter, and
Mechanical Device.
- Lap
Length / Multiplier
– When
Length is selected as the Lap Method , this
value set in the adjacent field will be used for bar laps.
When
Bar Diameter is selected as the Lap Method,
then type the diameter multiplier to use and the calculated lap length is shown
in the
Multiplier field.
It is disabled for
Mechanical Device method.
- Skipped
Rebar – Indicates the rebar being skipped due to threshold leg
length of bar.
Mechanical Device method enables the Manufacturer
/Device settings:
- Manufacturer –
Sets All or one of the Manufacturers from the drop-down list.
- Type – Displays
the types of laps. You can set All or one of the Types to narrow the devices
list.
- Device – Lists
the devices in a given type for the selected manufacturer. Select required
device from the list to proceed lap settings.
|
Automatic Lap
|
When checked, enables setting automatic lap:
- Maximum
Stock – Sets the percentage to use laps at the maximum bar length.
Type a percentage in the
% Over field to allow this amount over
the maximum length.
- Uniform
Length – When checked, makes bar lengths along all equal.
- Stagger
Laps – When checked, staggers the bar laps by the indicated
distance set in the next field.
- Stock
Length – Sets the bar stock length for the bar size used (default
is 60'-0").
- Min
Length – Sets the manufactured length for the bar size used
(default is 60'-0").
|
Manual Lap
|
When checked, enables setting manual lap:
- Stagger
Laps – When checked, staggers the bar laps by the indicated
distance set in the next field.
- Lap
Location – Sets the location for the lap, one selected from the
available options in the list.
- Clear
Span – Sets the span distance for manual laps.
- Location
Offset – Sets the location offset for the lap.
- Start
Embedded Length – Sets the embedded length of start of manual lap.
|