Used to generate a dynamic cross section (cut) view of the model at a given station.
Found on the Analysis and Reporting ribbon tab, in the Bridge Reporting group.
Tool Settings
| Setting | Description |
|---|
| Station |
Set this option to type a station along the alignment. |
| Skew Angle |
Set this option to type a skew angle of the cut for the view. Angle measured from normal to alignment. Clockwise is positive, and counterclockwise is negative.
|
| Depth |
Set this option to type a depth limit —measured along the alignment— for the view. Objects past this threshold will not appear in the view when the Cut With Depth option is selected. |
| Profile Type |
- Cut — Creates a cut view with unlimited depth. This option should typically be used to capture a 2D plan view at the station.
- Cut With Depth — Creates a cut using the specified depth to limit objects. Any objects beyond the cut plane will also appear in the view.
|
| Half Callout |
Set this option to generate a dynamic view of just half the bridge width. This is useful for a wide or symmetric bridge.
Typical callout (A) and half callout (B)
|
Key-in:
bmreport
reports
dynamicview
