| Angle Shape
|
- Shape
Type – Sets the type of shape. Default is
DIN_WINKEL_UNGLEICH.
- Shape
Size – Sets the size of the shape. Default is
L100x75x9.
- Weld on
Support – When checked, the angle shape is welded on the support
shape.
|
| Cleat
|
- Cleat
Type – Sets the position of the cleat plate.
- Left– creates
the plate on the left side of the web of the connect shape.
- Right– creates
the plate on the right side of the web of the connect shape.
- Both– creates
two plates on both sides.
- Thickness –
Sets the plate thickness. A positive value determines the thickness. A negative
value is to be read as its absolute value. The default is 10 or 0.4 depending
on the units setting.
|
| End Plate
|
- Flat
File – When checked, creates plate by using flat type shape.
- Seated – When
checked, the
End Plate would seat on the lower flange of
the connect shape rather than attached on the end of the shape .
- Tolerance –
Sets the tolerance of the plate size to the size of the flat shape from the
shape database for determining whether or not the plate can be created by using
flat shape. A positive value determines the tolerance. A negative value is to
be read as its absolute value. The default is 1 or 0.04 depending on the units
setting.
- Thickness –
Sets the plate thickness. A positive value determines the thickness. A negative
value is to be read as its absolute value. The default is 10 or 0.4 depending
on the units setting.
- Height
Offset – Sets the offset of the
End Plate to the upper flange of the connect
shape. A positive value increases the height while a negative value decreases
the height. The default is 10 or 0.4 depending on the units setting.
|
