| Sort holes base on
|
Select the sorting order for holes in the output
file from the drop-down list:
Note: Sorting of
hole is based on Location (Ascending X-Coordinate) OR Diameter (Smaller to
bigger) OR Type (Sequence – 1. Complete hole 2. Countersunk 3. Step hole 4.
Marker hole 5. Blind hole).
Default type: Location
|
| Hole on Member Profile
|
Hole placement and alignment setting on selected
member profile.
|
| Profile Code
|
Select the profile for which you want to change the
placement and alignment settings.
| I |
I Profile |
| U |
U Profile |
| L |
L Profile |
| M |
Rectangular Pipe |
| B |
Plates, Flat Bars |
| C |
C Profile |
| T
|
T Profile |
| RO/RU |
Round/Pipe Profile |
| SO |
Special Profile |
Default value:
I Profile.
The preview to the right of the selection list
updates to show the profile shape / cross-section (with profile face marking)
for the selection.
Note: You must
select the profile code first and then make the changes to hole placement and
alignment for any profile in list.
|
| Reset
|
Resets the hole placement and alignment setting of
selected profile to default (i.e., according to DSTV specification).
|
| Hole Placement
|
Used to report the only complete (through) hole
placement from the selected web or flange faces.
- Report
web holes from – Select the web face from which you want to report
the hole information.
Note: The list
options change based on the profile selection. This option is only applicable
when the shape has one web with two faces (i.e., web of an
I profile).
- Report
flange hole from – Select the flange face from which you want tor
report the hole information.
Note: The list
options change based on the profile selection. This option is only applicable
when the shape has one flange with two faces (i.e., web of an
L profile).
Holes that are drilled within the AK boundaries
are only reported in the BO Block.
|
| Hole Alignment
|
Used to set the hole alignment for the top flange,
web, and bottom flange using the selected options. The output file will be
generated according to hole alignment selection.
|
| Top flange / Web / Bottom flange
|
Reports the hole alignment for the section element
per the selection. The output file with be generated according to the hole
alignment selection.
- Top of
flange – Reports the hole alignment for top flange as per the
selection in combo box. Default value: Centerline (for
L profile).
- Web – Reports
the hole alignment for web as per the selection in combo box. Default value:
Top of flange (for
I profile).
- Bottom of
flange – Reports the hole alignment for bottom flange as per the
selection in combo box. Default value: Centerline (for
L profile).
|
| Reset All
|
Resets all control to default values (i.e.,
according to DSTV specification).
|
