| Member Selection
|
Sets the current memebr#, selected from the
available connection members.
|
| WP to 1st bolt
|
Sets the Work Point distance to 1st bolt. This is
the center point for members in connection, used for detailing purpose.
|
| Longitudinal Spacing
|
Specifies the dimensions for lateral spacings at
Gusset side:
- Number – Sets
the number of bolts to be placed on the
X axis.
- Edge
Distance (w1) – Sets the distance from the start of the shape to
the center of the first bolt.
- Distance
Between (w2) – Sets the distance between the center of the bolts in
longitudinal direction.
- Edge
Distance (w3) – Sets the distance from the end of the shape to the
center of the last bolt.
Note: Applicable
for more than one Number of bolts.
- Slot
Length – Sets the slotted hole distance along longitudinal
direction.
|
| Transverse Spacing
|
Specifies the dimensions for vertical spacings at
Gusset side:
- Number – Sets
the number of bolts to be placed on the
Y axis.
- Edge
Distance (g1) – Sets the distance from the edge to the center of
the first bolt.
- Edge
Distance (g2) – Sets the distance between the center of the bolts.
- Distance
Between (g3) – Sets the distance between the center of the bolts.
|
| Bolts
|
- Bolt
Type – Sets the bolt style from the drop-down list.
- Diameter – Sets
the hole diameter of the selected bolt from the drop-down list of bolt diameter
table.
- Workloose –
Sets the clearance between bolt and hole diameter.
- Additional
Length – Sets an additional length to the bolts extension outside
the nut.
- Turn – When
checked, the bolt direction is inverted. Available when not welded.
- Weld – When
checked, the shapes are welded, instead of bolting.
Note: When set
to Weld, disables the Bolts and Spacing settings.
|
