| Dimensions
|
- Length – Sets
the length of the strap. A positive value determines the length. A negative
value is to be read as its absolute value. The default is 175 or 7 depending on
the units setting.
- Match
to Plate – When checked, matches strap to the plate length.
Disables
Length.
- Width – Sets
the width of the strap. A positive value determines the width . A negative
value is to be read as its absolute value. The default is 175 or 7 depending on
the units setting.
- Match
to Plate – When checked, matches strap width to the support shape
size. Disables
Width.
- Plate
Gap – Sets the gap between outer surface of the support pipe to the
plate (refer to the drawing above). A positive value determines the gap. A
negative value is to be read as its absolute value. The default is 0.
- Construction
Gap – Sets the gap between the center of the support pipe to the
center of the arc part of the strap. A positive value determines the gap . A
negative value is to be read as its absolute value. The default is 0 .
- Shape
Type – Sets the strap type selected from the drop-down list of
types of installed shape database. The default is the
DIN_RUNDSTAH.
- Shape
Size – Sets the strap size for the current shape type, selected
from the drop-down list. The default is the
RD16.
|
| Nut/Washer
|
- Nut
Type – Sets the nut type, selected from the standard bolt database.
- Nut
Size – Sets the nut size, selected from the drop-down list.
- Nuts – When
checked, creates one nut at the one side of the plate. Enables setting washers
and both sides.
- Both – Enabled
when
Nuts is checked. When checked,
creates nuts on both onside and inside of the plate.
- Washers – When
checked, creates one washer at the one side of the plate.
- Both – Enabled
when
Whasher and
Both(Nuts) are checked. When
checked, creates washers on both sides of the plate.
|
