Plate Funnel Enhanced - General Options tab

Used to define the dimensions and offsets of enhanced plate funnel.

Setting	Description
General Constraints (Inside Dimensions)	A (Dim) – Sets the height for the vertical plate at the top of the plate funnel. B (Dim) – Sets the height for the vertical plate at the bottom of the plate funnel. Int Height – Sets the vertical height of the plate funnel, excluding dimension A or B. O/A Height – Display the overall height of the plate funnel. The sum of above heights; A + B + Int Height. Wall Thick – Sets the thickness of all plates around the plate funnel (includes vertical and sloping plates).
Offsets and Rotations	X Offset – Sets the offset in the length direction. This value can be negative or positive. Y Offset – Sets the offset in the width direction. This value can be negative or positive. X & Y Offset Sym – When checked, equates the X & Y offsets, keeping both offset values same. Rotation Angle – Sets the rotation angle of bottom opening. Note: This angle can ONLY be from +90 to -90. The increment [+] or decrement [-] buttons step up or step down the rotation angle by the value set in the Rotation Angle Increment. Rotation Angle Inc – Sets the angle increment factor for rotation angle to increment [+] or decrement [-] in each step. This can only be a positive value.

Setting

Description

General Constraints (Inside Dimensions)

A (Dim) – Sets the height for the vertical plate at the top of the plate funnel.
B (Dim) – Sets the height for the vertical plate at the bottom of the plate funnel.
Int Height – Sets the vertical height of the plate funnel, excluding dimension A or B.
O/A Height – Display the overall height of the plate funnel. The sum of above heights; A + B + Int Height.
Wall Thick – Sets the thickness of all plates around the plate funnel (includes vertical and sloping plates).

Offsets and Rotations

X Offset – Sets the offset in the length direction. This value can be negative or positive.
Y Offset – Sets the offset in the width direction. This value can be negative or positive.
X & Y Offset Sym – When checked, equates the X & Y offsets, keeping both offset values same.
Rotation Angle – Sets the rotation angle of bottom opening.
Note: This angle can ONLY be from +90 to -90.

The increment [+] or decrement [-] buttons step up or step down the rotation angle by the value set in the Rotation Angle Increment.
Rotation Angle Inc – Sets the angle increment factor for rotation angle to increment [+] or decrement [-] in each step. This can only be a positive value.