The
Match and Extend Tool automates the Single Rebar
Distribution placement. The tool is used for placing additional rebars like
corner rebar, wall , slab , dowels etc.
Note: Match and Extend
Tool is accessed only through
Keyin.
- By selecting two
RebarSet, Single Rebar Distribution rebar is created automatically with
guidelines.
- Newly created
Single Rebar Distribution takes all bar
properties such as Bar size, Bar Grade, Coating, Spacing, Level etc from the
first RebarSet which the user selects.
- The
Match and Extend tool clears all the
previously used End Condition data automatically from Single Rebar Distribution
dialog before rebar getting placed and the new data is re-written according to
user input.
To stop
Corner bars before Vertical bars
- By selecting vertical
RebarSet from the second wall the rebar is placed.
Non
perpendicular Corner Walls with no direct connection
- By selecting the Non
perpendicular corner walls with no direct connection the rebar is placed.
T
Connection Wall
-
Case 1: By selecting the second RebarSet on
the direction the rebar is placed.
-
Case 2: By getting rebar leg on other
direction the rebar is placed.
Wall
vertical dowels from footing
- Run the Keyin.
proconcrete
add
singledistribution
matchextend
- By selecting wall vertical
RebarSet, the bar properties are taken and aligned.
- By selecting the second
RebarSet from footing the rebar is placed.
Slab to
Slab dowels with single leg
- Run the Keyin.
proconcrete
add
singledistribution
matchextend
- By selecting the first
slab RebarSet and the second slab RebarSet, the rebar is placed.
Key-in:
proconcrete
add
singledistribution
matchextend
