Beam Column Web Connection C1 - Support Holes tab

Used to set support holes along web and flanges.

Setting	Description
Support Flange / Web	Defines the number, distance and orientation of the holes on the flange or web of the Support shape. Horizontal Count – Sets the number of the holes in the direction of Y-Axis of the support shape. Default is 2. Horizontal Distance – Sets the distance between the end edge of the flange of the connect shape and the center of the first hole along the Y-Axis of the support shape. Default is 40 or 1.6 depending of the units setting. Note: Applicable only when the Joint Type is set to `Angle Shape`. Vertical Count – Sets the number of the holes in the direction of Support shape. Default is 3. Vertical Distance – Sets the distance between two adjacent holes along the direction of Support shape. Default is 40 or 1.6 depending of the units setting.
T-Shape Support Flange	Defines the distance and location of the holes in the flanges of the Support shape when T-Shape is selected as Support type. Horizontal Edge – Sets the distance between the edge of the flange of the connect shape and the center of the first hole along the Y-Axis of the support shape. It is only valid when the T-Shape is selected as Support type. Default is 40 or 1.6 depending of the units setting. Vertical Distance – Sets the distance between two holes a`long the direction of Support shape. It is only valid when the T-Shape is selected as Support type. Default is 100 or 4 depending of the units setting.

Setting

Description

Support Flange / Web

Defines the number, distance and orientation of the holes on the flange or web of the Support shape.

Horizontal Count – Sets the number of the holes in the direction of Y-Axis of the support shape. Default is 2.
Horizontal Distance – Sets the distance between the end edge of the flange of the connect shape and the center of the first hole along the Y-Axis of the support shape. Default is 40 or 1.6 depending of the units setting.
Note: Applicable only when the Joint Type is set to Angle Shape.
Vertical Count – Sets the number of the holes in the direction of Support shape. Default is 3.
Vertical Distance – Sets the distance between two adjacent holes along the direction of Support shape. Default is 40 or 1.6 depending of the units setting.

T-Shape Support Flange

Defines the distance and location of the holes in the flanges of the Support shape when T-Shape is selected as Support type.

Horizontal Edge – Sets the distance between the edge of the flange of the connect shape and the center of the first hole along the Y-Axis of the support shape. It is only valid when the T-Shape is selected as Support type. Default is 40 or 1.6 depending of the units setting.
Vertical Distance – Sets the distance between two holes a`long the direction of Support shape. It is only valid when the T-Shape is selected as Support type. Default is 100 or 4 depending of the units setting.