| Without Holes
|
When checked, disables hole settings. The connection
plate is created without drill holes.
|
| Vertical
|
The drill hole spacing in a vertical direction
(height) is determined. Depending on the entry, the values have different
meanings. Examples are given at the end of the command description.
- Asymmetrical –
When checked, the structure of the hole pattern input changes and a list with
an input field appears. Depending on the number of holes, you can determine
each distance individually by clicking the position in the list and by
specifying the distance in the input field.
- Number – Sets
the number of holes in vertical direction.
- Upside – Sets
the distance of the upper row of holes from the plate’s upper edge. If this
value is
0, and the value in the box
Downside is also
0, the only entry that will be used is
in the
Middle field.
- Middle – Sets
the distance of the first and second row of holes from the upper and lower
plate edge. The holes will be distributed uniformly between the two outer holes
if this value is
0. The other rows of holes will be
arranged in the same manner if the number is greater than
4.
- Offset – Sets
the distance of the lowest row of holes from the plate’s lower edge. If this
value is
0, and the value in the box
Upside is also
0, the only entry that will be used is
in the
Middle field.
- Downside – Sets
the value used to simultaneously shift all rows of holes with respect to the
plate upper edge. If you enter a negative value, shifting will be carried out
with respect to the plate lower edge.
- Measured
from – Sets at asymmetrical distribution from which position the
distribution of drill holes starts. Selected one of the options from Upper Edge
Plate, Upper Edge Shape or Lower Edge Shape.
|
| Horizontal group
|
The drill hole spacing in a horizontal direction
(width) is defined here. Examples are given at the end of the command
description.
- Number – Sets
the number of holes in horizontal direction.
- Left – Sets the
distance between the outer left row of holes and the central left row of holes,
if the number of rows is 4.
- Middle – Sets
the distance between the two inner rows of holes. The rows of holes are
generally arranged centrally, unless they are offset by an entry in the
Offset field.
- Right – Sets
the distance between the outer right row of holes and the central right row of
holes, if the number of rows is 4.
- Offset – Sets a
simultaneous shifting of all rows of holes with respect to the right plate
edge. If you enter a negative value, shifting will be carried out with respect
to the left plate edge.
|
