Prompt

User Action

Locate First Superelevation Section

Select the first section. To create lanes in multiple sections without having to do them individually, create a selection set of the sections. This can be done prior to selecting the tool or interactively by dragging your cursor diagonally across all desired sections.

Locate Next Superelevation Section - or Reset to Complete

Continue selecting sections until all are highlighted, then reset to move to the next prompt.

Enter Lane Name

Name each lane, suggestions include RT or LT which can be appended -1, 2, etcetera. for projects with multiple lanes. Note these names should be unique if your project has multiple corridors.

Type

Select Primary. After the selection, the dialog/heads- up prompts change to reflect the selection.

Select Side of Centerline

Right or left.

Inside Edge Offset

Enter the offset (in master units) from the baseline reference. If the lane edge is the baseline reference, enter 0.

Width

Enter the width of the lane (in master units).

Normal Cross Slope

Enter the default cross slope to be used for calculations (in percent format). It not necessary to add the percent sign.

Name

The prompts are looping again, so you can define multiple lanes with a single selection of the tool. You may need to move the cursor slightly for the prompt to appear. When you have no additional lanes to define, reset to exit the tool.