OpenBridge Modeler

Single Rebar Distribution - End Conditions tab

Used to add hooks or bends to the reinforcement bar.

Used to add end conditions to either or both ends of the rebar.

The following descriptions apply to all start and end options.

Setting	Description
Type	Select the type of end condition for each position: Bend – A hook end. Hook – Two 90° bends, creating a hooked parallel leg. Crank – Offset bar 90 Degree Hook – Same as a `Bend`, but with the angle set at 90°. 135 Degree Hook – Same as a `Bend`, but with the angle set at 135°. 135 Degree Seismic Hook – Same as a `135 Degree Hook`, but with the lengths specified for seismic detailing. 180 Degree Hook – Same as a `Bend`, but with the angle set at 180°. Or, a hook with a single bend. Projection – Additional straight length. User – User-entered condition with two bends.
Edit End Condition Values	When you select an end condition type, the standard values and angle are applied. If necessary, click Edit End Condition Values to enter custom end condition settings. See Rebar End Properties dialog.
Offset (Extension)	(Where Applicable) Positive (extends the bar) or negative (shortens the bar) the specified distance from the edge of the concrete element.
Rotation	Type a rotation angle (in degrees). Click to rotate the bar by increments of 90 degrees.

Tip: For additional details, Working With End Conditions.