Pipe Strap Connection - Plate tab

Used to set plate dimensions and holes on the end plate.

Setting	Description
Dimensions	Length – Sets the length of the end plate. A positive value determines the length. A negative value is to be read as its absolute value. The default is 400 or 16 depending on the units setting. Width – Sets the width of the end plate. A positive value determines the width. A negative value is to be read as its absolute value. The default is 400 or 16 depending on the units setting. Thickness – Sets the thickness for the end plate. A positive value determines the thickness. A negative value is to be read as its absolute value. The default is 10 or 0.5 depending on the units setting.
Holes	Match Strap – When checked, the hole size (diameter) and position is based on the strap. Disables Diameter. Diameter – Sets the diameter of the holes in the end plate. A positive value determines the diameter. Default is 16 or 0.625 depending on the units setting. Workloose – Sets the allowance for the holes workloose for the hole in the end plate. A positive value determines the workloose. Default is 1 or 0.05 depending on the units setting. Vertical Spacing – Sets the distance between the holes in vertical direction. A positive value determines the distance. A negative value is to be read as its absolute value. The default is 175 or 7 depending on the units setting.

Setting

Description

Dimensions

Length – Sets the length of the end plate. A positive value determines the length. A negative value is to be read as its absolute value. The default is 400 or 16 depending on the units setting.
Width – Sets the width of the end plate. A positive value determines the width. A negative value is to be read as its absolute value. The default is 400 or 16 depending on the units setting.
Thickness – Sets the thickness for the end plate. A positive value determines the thickness. A negative value is to be read as its absolute value. The default is 10 or 0.5 depending on the units setting.

Holes

Match Strap – When checked, the hole size (diameter) and position is based on the strap. Disables Diameter.
Diameter – Sets the diameter of the holes in the end plate. A positive value determines the diameter. Default is 16 or 0.625 depending on the units setting.
Workloose – Sets the allowance for the holes workloose for the hole in the end plate. A positive value determines the workloose. Default is 1 or 0.05 depending on the units setting.
Vertical Spacing – Sets the distance between the holes in vertical direction. A positive value determines the distance. A negative value is to be read as its absolute value. The default is 175 or 7 depending on the units setting.