| Clearances
|
Sets the dimension from the edge of concrete to the
closest rebar (Top, Bottom, Side, and End values).
|
| Top Rebar / Bottom Rebar
|
When checked, enables adding top / bottom bars.
Both
Longitudinal and
Transversal bar details can be set.
- Qty – Sets the
quantity of the selected bars.
- Bar
Size – Sets the size of the bar selected from the drop-down list.
- Spacing
– Sets the distance between bars in the X and Y
direction.
- Layout – Sets
the bar alignment mode; either top, bottom, center aligned or rounded up/down.
- Start
Offset – When checked, allows setting offsets.
- Start /
End Offset – Sets the distance between bars in the X and Y
direction, respectively.
- Type (for
Transversal) – Sets the bar type; either
Straight or
U-Bar. For Transversal bar, however the Type
can also be set to
Closed.
Note: Setting the Type
Closed for Bottom Rebar, will override the
Top Rebar Transversal bar, and disables the settings, as well as the
Above toggle.
- Above – When
checked, toggles to position whichever bars are in Y-direction bars or
X-direction bars, only one can be checked.
|
