| Connect Web
|
Defines the number, position and orientation of the
holes in the web of the connect shape.
- Horizontral
Count – Sets the number of the holes in the direction of connect
shape. Default is 2.
- Horizontral
Distance – Sets the distance between two adjacent holes along the
direction of connect shape. Default is 75 or 3 depending of the units setting.
- Horizontral
Edge – Sets the distance between the end edge of the web and the
center of the first hole along the direction of connect shape. Default is 25 or
1 depending of the units setting.
- Vertical
Count – Sets the number of the holes in the direction of Y-Axis of
the connect shape. Default is 2.
- Vertical
Distance – Sets the distance between two adjacent holes along the
direction of Y-Axis of the connect shape. Default is 80 or 3 depending of the
units setting.
|
| Connect Web Cut
|
Defines the dimensions of the poly-cut on the web and flanges
of the connect shape .
- Cut Web
Offset – Sets the offset of the web to be cut to the
edge of the flange in the direction of connect shape. Default is 10 or 0.4
depending of the units setting.
- Cut
Radius – Sets the round cut radius of the web poly-cut. Default is
30 or 1.2 depending of the units setting.
- Flange
Chamfer X – Sets the dimension of the cut on the flanges of the
connect shape along the direction of X-Axis of the shape to allow welding. A
positive value will set the cut length along horizontal direction of the
connect shape. A negative value is to be read as its absolute value. Default is
5 or 0.2 depending of the units setting.
- Flange
Chamfer Y – Sets the dimension of the cut on the flanges of the
connect shape along the direction of Y-Axis of the shape to allow welding. A
positive value will set the cut height along vertical direction of the connect
shape. A negative value is to be read as its absolute value. Default is 5 or
0.2 depending of the units setting.
|
| Connect Flange
|
Defines the number, distance and orientation of the
holes on the flanges of the connect shape.
- Horizontal
Count – Sets the number of the holes in the direction of connect
shape. Default is 2.
- Horizontal
Distance – Sets the distance between two adjacent holes along the
direction of connect shape. Default is 75 or 3 depending of the units setting.
- Horizontal
Distance – Sets the distance between the end edge of the flange and
the center of the first hole along the direction of connect shape. Default is
25 or 1 depending of the units setting.
Note: Applicable
only when the
Support Type is set to
T-Shape.
- Vertical
Edge – Sets the offset of the center of the outer holes to the edge
of the flange along the direction of X-Axis of the connect shape. Default is 25
or 1 depending of the units setting.
|
