| Holes
|
Defines the number and distance of the holes on the plate and the
web of the connecting shape.
- Diameter – Sets
the dimension of the holes. A positive value determines the diameter. A
negative value is to be read as its absolute value. The default is 16 or 0.6
depending on the units setting.
- Workloose
– Sets the workloose of the holes. A positive
value determines the workloose . A negative value is to be read as its absolute
value. The default is 1 or 0.04 depending on the units setting.
- Number
Horz / Vert
- Sets the number
of the holes in the direction of connecting shape. Default is 1
- Sets the number
of the holes in the direction of Y-Axis of the connecting shape. Default is 2.
- Horiz
Distance
– Sets the distance between two adjacent holes
along the direction of connecting shape. Default is 40 or 1.6 depending of the
units setting.
- Vert
Distance
– Sets the distance between two adjacent bolts
along the direction of Y-Axis of connecting shape. Default is 40 or 1.6
depending of the units setting.
- Edge
Offset – Sets the offset of the center of the hole to the edge of
the plate along the direction of the connecting shape. Default is 20 or 0.8
depending of the units setting.
- End
Offset – Sets the offset of the center of the hole to the end of
the connecting shape along the direction of the connecting shape (refer to the
picture below). Default is 20 or 0.8 depending of the units setting.
|
| Bolts
|
- Create
Bolts – When checked, creates the bolts.
- Flip
Bolts – When checked, flips the created bolts in the reverse
direction.
- Bolt
Type – Sets the type of the bolt being created. The default
is DIN 7990.
|
| Measurement
|
- From
Edge – When checked, the measurement can be set from upper edge.
Enables theUpper Edge and
From First Bolt
settings
- Upper
Edge – When checked, sets the measurement from the upper edge of
connecting shape.
- From
First Bolt – When checked, sets the measurement from the first
bolt.
|
